I am having issues getting dsc and szl pairing, help please?Hello Guys,
Ive done with 95% of the Electric Part of Convertation:
M3 Steering with Paddels & MuFu
M3 DSC MK60
Wiring is Done, Wires to MK60 and to MSD81 are installed.
flashed the M3 GTS Software
flashed the 1er M Software (IKM0S)
Coded the VO for M Drive and M DCT
Coded the M3DSC, Kombi, CIC, MSD81 and GWS
i thing all is installed except the4 M3 DSC Sensors, are they necessary?
Other Quetion, does the M3 LSD Fit with the 335i driveshafts? someone say yes, other say no.
Edit: no Error Codes, DSC OFF is Work, M button Work (Green M Light Turned On) Power Bottun no funktion (No change and no Light turned on after push) iDrive Changes in M Display (CIC) dont work
I did try the PM91. But was no diff, actually was like most of the coding was done, all cic and kombi options were selected. What i do not understand is the szl serial invalid code.Maybe try a normal M3 code? CRT/GTS has some specific files and modules/coding/pins may not be the same as normal M3s. Don't jump into the deep end to start, make it as easy as possible to get working as intended and then mess around with the questionable options after if you want.
Have you been able to get the VIN written to the DSC at all? That would be step 1 I'd think.I did try the PM91. But was no diff, actually was like most of the coding was done, all cic and kombi options were selected. What i do not understand is the szl serial invalid code.
After a few hrs or troubleshooting.. figured out with help of Roma in Europe that one of my VO values was conflicting. After we identified it NCS expert is back online. So fixing my VO got me a step closer. CORRECTEDThe only other thing I can think is that the files it's using aren't correct based on the selection or dates. Might try running through files in Tools32 and see which, if any, can read the DSC or EGS or if there is a comm error before you even get that far.
After a few hrs or troubleshooting.. figured out with help of Roma in Europe that one of my VO values was conflicting. After we identified it NCS expert is back online. So fixing my VO got me a step closer. CORRECTED
Next we found out my pining of the yaw pin1 does not go to pin 28 on dsc but to pin 26. CORRECTED then i was able to default code my M3DSC. But not able to code the M3SZL.
Next we found that F-CAN had an issue. Next is troubleshooting that part tomorrow. Anyone input?
The yaw pins need to be like this. Not like the other post shows..Progress at least. I've seen SZL is coded through DSC, including M3 (MK60_M3.xxx). Do you have a separate "M3SZL" module listed with the VO you're using?