Mosfets, codes and clouds

[R.G.]

MOSFET's usually fail and damage injectors. I hope you replaced all of the mosfets, not just the failed one. The person doing the repair should have used an air station, not an iron, if they used an iron 9/10 chance they ruined something. These things are important for a proper repair.

Yea, all mosfets were replaced. Not certain regarding equipment used as my buddy dealt with that. I've used him in the past to repair a pin in my dme that became recessed. Probably lucky I didn't have additional issues as an iron was used at the time.

 

[doublespaces]

Well sounds like we have a nominee for culprit. Swap that DME and we can all sleep at night

 

[R.G.]

As a follow up / closure in case some poor sap is trying to fix his ish and finds this thread looking for answers. It was the DME. Buddy contacted Vader Solutions and had the DME swapped and poof problems went away.

 

[doublespaces]

Think it was the result of the soldering job?

 

[R.G.]

Think it was the result of the soldering job?

No, I think the board had another issue. MSD80s are garbage IMO