Wanted to check my plugs and having a issue removing my PR Coil boot from my plugs.they are on very tight and my boots sit little inside the plug hole,whats the best way to remove them?
PR Boot Removal Help
- Thread starter BOosted 335i
- Start date
nothing ripped(yet)i tried pulling up by the round boot but was afraid to put force as to it might rip
I don't have them personally but I heavily considered them and spoke to PR about them a lot. My understanding is you lift up the "skirt" to help break suction, and then pull from the base (aka the part under the skirt, at the top of your plug cylinder)
Well,I tried that and boot came out but left part of the inside on plug.looks like I'm up sheets creek.
Attachments
i did put grease prior to install
https://www.amazon.com/CRC-Technici...&sr=8-1&keywords=crc+05113&tag=clicksource-20
I bought the same grease, and it caked up and got a little stuck. I used wd40 and it came out.
I used what was recommended.nothing caked up at all.in this case I don't think that caused a issue.as you can see.
Attachments
I had this happen to me with their original wires. The new ones seem much better. Contact them and they will work with you to get you a replacement wire or set.
New wires fit much better.
I did have an issue with several of my wires being pulled through improperly by the factory, meaning that they had to really be shoved in for the plug to clip on. This resulted in the plug and wire popping off, which is not good.
Sent photo proof and got new wires, no more problems.
I did have an issue with several of my wires being pulled through improperly by the factory, meaning that they had to really be shoved in for the plug to clip on. This resulted in the plug and wire popping off, which is not good.
Sent photo proof and got new wires, no more problems.
