S58 Technical Document

doublespaces

Administrator
Oct 18, 2016
9,303
4,331
0
AZ
Ride
2009 E93 335i
29281
 

Attachments

  • ST1926-S58-Engine.pdf
    5.1 MB · Views: 121

Jeffman

Major
Jan 7, 2017
1,618
1
628
0
Unlike the introduction of the N54, it looks like BMW is taking cooling in a competitive environment quite seriously in the S58:

According to BMWBlog:
“Three large radiators, an additional engine oil cooler and a separate transmission oil cooler keep the temperatures under control. A map-controlled oil pump with additional suction stage in conjunction with the oil sump, which has two chambers and an integrated suction channel, enables reliable lubrication even at high lateral accelerations.”
 
  • Like
Reactions: doublespaces

doublespaces

Administrator
Oct 18, 2016
9,303
4,331
0
AZ
Ride
2009 E93 335i
Here are cliff notes:

They've dropped the CR from 10.2 to 9.3
29714


Oil sump is cast aluminum AlSi9Cu3
Crankcase is gravity die-cast Al Si 7 Cu 0.5 Mg
29715


29716


And everyone's favorite subject:

29717

29718


Crankshaft is a steel alloy 42CrMoS4 Mod which is nitrocarbonized. Lower bearings are Federal Mogul G488 and uppers are G490. Rods are taken from the S64B44T4.

29719


Forged 'slipper-skirt' pistons are made by Mahle. Material is M142P alloy.

29720


29721


29722

29723


The turbos are off-set and the turbine housings are part of the manifold:
29724


29726

29727

29728


DME is made by Bosch: DME 8.6.S (Gen8, 6 cylinders, M Sport)
29729
 
Last edited: