Hello,
I was doing some rescaling on my vanos table and ignition table axises in tunerpro today.
It seems like it's not getting back into the ecu. Wondering what I am doing wrong.
This is the timing table, where I modified the load axis.
And here is the timing table as logged:
Timing correction are 0.
Also changing the rpm on the Vanos tables had 0 effect.
Any idea what that could be?
Thanks,
Falko
I was doing some rescaling on my vanos table and ignition table axises in tunerpro today.
It seems like it's not getting back into the ecu. Wondering what I am doing wrong.
This is the timing table, where I modified the load axis.
And here is the timing table as logged:
Timing correction are 0.
Also changing the rpm on the Vanos tables had 0 effect.
Any idea what that could be?
Thanks,
Falko