CAN_ID_HEX CAN_ID_NAME CAN_ID_NAME (Translated) DIAG_ID_HEX SG_NAME
0x206 Steuerung Anzeige Shiftlights [1] Control Display Shiftlights [1] 0x12 DME1
So with this the board is the same between yours and a M3 DCT there is just LEDs soldered and other add-ons like the rpm warning gauge....however the flash on the MCU is also different, also those lights only work from the DME controlling it. The MSS65 DME has a specific wire for it that MSD80/81 does not... however with the new reflex plus and CAN integration this can be done and could be controlled by just creating a table to send that signal once a rpm limit is reached but it will take a bit of R&D to get it to work well.
You can get then for a out 275.00 on ebayYes, I am planning to buy M3 cluster in the future (its aint cheap though), but first I want to know if it works with simulated can bus message. So basically I want to debug and see it in action first.