Hi guys.
I have a huge problem.
I went ahead and tried to load INA0S onto my car (2009 335i N54 DCT).
I have research and spoken to alot of people to ensure i had the info i needed.
First issue
I put JB4 into Map0.
Opened WinKFP, selected the MSD81 iption and chose ZB# 8671658
The Progress bar went to 100% 4 times and then said Programming OK.
I plugged in my MHD and checked error codes. And saw i had the DME Incorrect Data Record.
I then updated the INA0S BEF bits 4BD9D+E from 00 to 01 as instructed.
I loaded the INA0S BEF, and it said Full write 18 - 38min. But completed successfully in 17min. However the car does not start.
I tried to flash back to stock and it requested a 2min write. It completed successfully, then car didnt start.
Wrote back to stock again. Requested Long wrote and then it completed successfully again. And i could start the car.
I noticed that the Current Software in MHD did not read the same ZB# i flashed for INA0S
I tried this plenty.
Have also tried to flash the original IJE0S Current Software i had, and it flashed via WinKFP successfully.
But still if i flash a BEF for IJE0S it flashes successfully. But car doesnt start. Have all the faults on iDrive. Car just swings over.
In MHD, Last Flashed file is Blank.
Could this be a MHD issue since the new update for Full Writes? As no full wrote goes the distance. Always stops at 17min. Then says Success.
Any help here at all please.
Was flashing Via WinKFP to the DME with a BEF loaded a mistake?
I have a huge problem.
I went ahead and tried to load INA0S onto my car (2009 335i N54 DCT).
I have research and spoken to alot of people to ensure i had the info i needed.
First issue
I put JB4 into Map0.
Opened WinKFP, selected the MSD81 iption and chose ZB# 8671658
The Progress bar went to 100% 4 times and then said Programming OK.
I plugged in my MHD and checked error codes. And saw i had the DME Incorrect Data Record.
I then updated the INA0S BEF bits 4BD9D+E from 00 to 01 as instructed.
I loaded the INA0S BEF, and it said Full write 18 - 38min. But completed successfully in 17min. However the car does not start.
I tried to flash back to stock and it requested a 2min write. It completed successfully, then car didnt start.
Wrote back to stock again. Requested Long wrote and then it completed successfully again. And i could start the car.
I noticed that the Current Software in MHD did not read the same ZB# i flashed for INA0S
I tried this plenty.
Have also tried to flash the original IJE0S Current Software i had, and it flashed via WinKFP successfully.
But still if i flash a BEF for IJE0S it flashes successfully. But car doesnt start. Have all the faults on iDrive. Car just swings over.
In MHD, Last Flashed file is Blank.
Could this be a MHD issue since the new update for Full Writes? As no full wrote goes the distance. Always stops at 17min. Then says Success.
Any help here at all please.
Was flashing Via WinKFP to the DME with a BEF loaded a mistake?